This is a guide on how to use the MREV-SPRINGS plugin.

A spring reverb with four different units.

Modify the intensity and add pre-delay or modulation to the signal. Use high pass and low pass filters on each channel. Dial-in the amount of dry signal and adjust how much wet signal of reverb is added.

Additional Features

  • Push the signal to soft clip by increasing the input slider beyond zero dB.
  • The EQ has built-in Mid-Side processing capabilities and output gain and phase controls.
  • A-B comparison
  • Preset functionality (includes a selection of factory presets)

The EQ operates in stereo mode or dual-mono mode.

Stereo Channel View of the MREV Springs Plugin
Mono Channel View of the MREV-SPRINGS Plugin
Mono Channel View of the MREV-SPRINGS Plugin

The input level can be adjusted between the values -∞dB to 12dB, using the input slider. Soft clipping occurs if the input signal moves above zero dB.

Main Panel

There are two separate outputs, which include a dry signal and springs.

  • Each of the outputs can be enabled/bypassed using the activation button below each of the four outputs.
  • Each output has a high pass and low pass filter attached. This can be used to adjust the signal that is affected.
  • The reverb outputs can be controlled using the following parameters:
    • Intensity: increases the impact of the reverb
    • Modulate: applies a modulation signal to the reverb
    • Wet: Changes the amount of reverb signal applied
    • Pre Delay: Applies a pre-delay to the reverb signal

Controller Panel

MSLR (Mid/Side/Left/Right)

MREV-MIXER stereo controller panel
MREV-MIXER stereo controller panel

In stereo mode, the MSLR panel will appear. The MSLR panel allows the processing and the output to be controlled.

  • Select either Mid (M), Side(S), Left(L) or Right(R) or All(A) channels to activate.
  • Selecting the A button will process the left and right channels using the settings in the active main panel.
  • Selecting either M or S will perform Mid/Side processing while selecting L or R will perform LR processing. Each channel will be processed using a separate main panel for each channel.
  • Pressing either L or M will activate a panel with a grey border OR pressing R or S will activate a panel with an orange border. Settings can then be adjusted for the grouping selected.
  • If any of the MSLR buttons are active, activating the link button (situated between the LM group and the RS group) will cause both channels to be processed. If the link button is not active, then the channel selected will be unprocessed, while the other corresponding channel will be left untouched. Both signals will combine to form the output.
  • The Solo buttons (speaker buttons at the top of the group allow either channel to be muted. For instance, if M is active but S should be muted, then disable the speaker above the RS group.

Output Slider

The output slider allows the signal output to be adjusted between -∞dB and 12dB.

  • Disable the link button between the Out L and Out R to allow the sliders to move independently.
  • Use the phase buttons below each slider to toggle the phase of either the left or right channel.

Reset Button

The reset button (circular arrow button below the output slider group of controls), can be pressed to reset the plugin to factory defaults.

Top Menu (Presets and A-B Comparison)

Top menu with A-B comparison, presets and bypass functionality

The top menu provides the following functionality:

  • Bypass option
  • A-B Comparison functionality: Click the A-B button to initiate the comparison. Make changes to the settings and then click the A-B button again to compare with the original. Click the Keep button to keep the preferred version ie. A or B.
  • Preset functionality: Select from the list of factory presets or save your own by clicking the Save Preset button. Click the Delete Preset button to delete a preset.